2. Using the Asynchronous Terminal Interface7990-A2-GB20-20 September 2004 2-7ProcedureTo make a menu or field selection:1. Press the Tab key or the right arrow key to position the cursor on a menu orfield selection. Each selection is highlighted as you press the key to move thecursor from position to position.2. Press Enter.The selected menu or screen appears.3. Continue Steps 1 and 2 until you reach the screen you want.The current setting or value appears to the right of the field name. You can enterinformation into a selected field by: Typing in the first letter(s) of a field value or command. Switching from the screen area to the function key and message area belowthe dotted line and selecting or entering the designated function key.If a field is blank and the Field Values screen area displays valid selections, pressthe spacebar. The first valid value for the field will appear. Continue pressing thespacebar to scroll through other valid values.Function KeysAll function keys located below the dotted line operate the same way (upper- orlowercase) throughout the screens.For the screenfunction . . . Select . . . And press Enter to . . .ClrFar F or f Clear far-end network statistics and refresh the screen.ClrNear N or n Clear near-end network statistics and refresh the screen.ClrStats S or s Clear statistics and refresh the screen.Delete L or l Delete data.Exit E or e Terminate the asynchronous terminal session.MainMenu M or m Return to the Main Menu screen.New N or n Enter new data.PgDn D or d Display the next page or group of entries.PgUp U or u Display the previous page or group of entries.Save S or s Save information.
