2. Using the Asynchronous Terminal Interface2-8 September 2004 7990-A2-GB20-20Switching Between Screen Work AreasSelect Ctrl-a to switch between the two screen work areas to perform all screenfunctions.ProcedureTo access the screen function area below the dotted line:1. Press Ctrl-a to switch from the screen area to the function key and messagearea below the dotted line.2. Select either the function’s designated (underlined) character or press the Tabkey until you reach the desired function key.Example:To save the current screen, type s or S (Save).3. Press Enter.4. To return to the screen area above the dotted line, press Ctrl-a again.Ending an ATI SessionUse the Exit function key from any screen to terminate the session.ProcedureTo end a session with the asynchronous terminal interface:1. Press Ctrl-a to go to the function key and message area below the dotted line.2. Save changes if required. A confirmation message appears if you have madebut not saved changes to your configuration.3. Tab to Exit (or type e or E) and press Enter.main/config/dsl_interfaceModel: 799xDSL INTERFACE OPTIONSEstimated Line Length: LongStartup Margin: 0dBMax DSL Rate: 2056 KbpsMin DSL Rate: 2056 KbpsEIA-530 Payload Rate: 2048 KbpsRemotely Initiated Loopback: EnablePeer IP Address: 135.090.025.001 ClearCircuit Identifier: Clear--------------------------------------------------------------------------------Ctrl-a to access these functions, ESC for previous menu MainMenu ExitSave
