Paradyne Hotwire 7995 User Manual

Also see for Hotwire 7995: Quick installation instructions User guide Installation instructions User guide

Contents

Paradyne Hotwire 7995 User Manual Manual pdf 64 page image

6. Monitoring and Troubleshooting6-8 May 2002 7990-A2-GB20-00Entry Response MessagesThe messages in Table 6-4, Entry Response Messages, can appear in responseto commands or during data entry. They appear in the messages area at thebottom of the ATI screen and are listed in alphabetical order.Table 6-4. Entry Response Messages (1 of 2)Device Message What Message Indicates What To Do0.0.0.0 is an invalidIP addressAn IP address of all zeroswas entered.Enter a valid, non-zeroIP address.Access level isOperator.Configuration isread-only.The operator requested thatconfiguration options beloaded, but does not haveauthority to edit them.If configuration options are to beedited, use a Login ID that hasAdministrator authority.Cannot Save – noLogin IDs with AccessAdministratorAll of the login IDs beingsaved have an access levelbelow Administrator.Change the access level ofat least one Login ID toAdministrator so thatconfiguration changes can bemade. (Operator-level userscannot make configurationchanges.) Save the Login IDs.Command Complete Action requested hassuccessfully completed.No action is needed.Invalid Character A nonprintable ASCIIcharacter has been entered.Reenter the information usingvalid characters.Invalid – Data TerminalInitiated LoopbackActiveNetwork-initiated loopbackwas in progress when theselection was made.No action is needed.Invalid entry at cursor Invalid IP address for thisfunction.Enter a valid IP address. See theappropriate table in Appendix A,Configuration Options, todetermine the permitted addressrange for this field.Invalid Password Login is required and anincorrect password or LoginID was entered; access isdenied. Enter the correct Login IDand password combination. Contact your systemadministrator to verify yourLogin ID and password.Invalid –[Test] AlreadyActiveThe described test wasalready in progress when theselection was made. Allow the test to continue. Select another test. Stop the test.Invalid TestCombinationA loopback or pattern testwas in progress when Startwas selected to start the test,or was active on the sameinterface when the test wasselected. Wait until the other test ends. Abort all tests from the Testmenu screen. Stop the test from the samescreen from which the testwas started.