6. Messages and Troubleshooting6-2 February 2001 8700-A2-GB25-10Configuring SNMP TrapsAn SNMP trap can be automatically sent out through the EOC or the Managementport to the SNMP manager when the termination unit detects conditions set by theuser. These traps enable the SNMP manager to gauge the state of the network.Refer to Appendix B,Standards Compliance for SNMP Traps, for details of SNMPtraps supported by the unit.To configure the unit for SNMP traps, use the SNMP Traps Options screen to: Enable SNMP traps. Set the number of SNMP managers that receive SNMP traps from the unit. Enter an IP address and network destination for each SNMP managerspecified. Select the type of SNMP traps to be sent from the unit.To configure SNMP Traps, follow this menu selection sequence:Main Menu→Configuration→Current Configuration→Management and Communication→SNMP TrapsRefer to Table A-8, SNMP Trap Options, in Appendix A,Configuration Options, forinformation about these options.main/config/management/trap HotwireSlot: 4 Model: 87x5SNMP TRAPS OPTIONSSNMP Traps: Enable Number of Trap Managers: 5NMS 1 IP Address: 135.014.040.001 Clear Destination: IMCNMS 2 IP Address: 135.014.003.027 Clear Destination: IMCNMS 3 IP Address: 135.014.001.008 Clear Destination: IMCNMS 4 IP Address: 135.014.002.024 Clear Destination: IMCNMS 5 IP Address: 204.128.146.035 Clear Destination: IMCGeneral Traps: BothEnterprise Specific Traps: EnableLink Traps: BothLink Traps Interfaces: Network--------------------------------------------------------------------------------Ctrl-a to access these functions, ESC for previous menu MainMenu ExitSave
