Parmco FS60R-8W Installation And Operating Instructions Manual

Contents

Parmco FS60R-8W Installation And Operating Instructions Manual Manual pdf 5 page image

INSTALLATIONInstalling the cookerThe kitchen should be dry and airyand have effective ventilationaccording to the existing technicalprovisions.The room should be equipped with aventilation system that pipes awayexhaust fumes created duringcombustion.This system shouldconsist of a ventilation grid or hood.Hoods should be installed accordingto the manufacturer’s instructions.The cooker should be placed so as toensure free access to all controlelements.Coating or veneer used on fittedfurniture must be applied with a heatresistant adhesive (100℃ ).Thisprevents surface deformation ordetachment of the coating. If you areunsure of your furniture’s heatresistance, you should leaveapproximately 2 cm of free spacearound the cooker. The wall behindthe cooker should be resistant to hightemperatures. During operation , itsback side can warm up to around50℃ above the ambient temperature.The cooker should stand on a hard,even floor (do not put it on a base.)Before you start using the cooker itshould be leveled, which is particularlyimportant for fat distribution in a fryingare accessible after removal of thedrawer. The adjustment range is +20mm.Electrical connectionCaution!All electrical work should be carried out by a suitably qualified and authorized electrician.No alterations or willful changes in the electricity supply should be carried out.Fitting guidelinesThe cooker is manufactured to work with three-phase alternating current (400V 3N~50Hz).The voltage rating of the cooker heating elements is 230V. Adapting the cooker to operatewith one-phase current is possible by appropriate bridging in the connection box accordingto the connection diagram below. The connection diagram is also found on the cover of theconnection box. Remember that the connection wire should match the connection type andthe power rating of the cooker.CONNECTION DIAGRAMCaution! Voltage of heating elements 230VCaution! In the event of any connection the safetyWire must be connected to the E terminal.Recommendedtype ofconnectionlead1 For 220-240V earthed one-phaseconnection, bridges connect 1-2-3terminals and 4-5 terminals, safetywire toL1NEH05VV-F3G42 For 380-415/220-240V earthed three-phase connection, bridges connect 4-5 terminals, phases in succession 1,2and 3, earth to 4-5, the safety wire to NEL1 L2 L3H05VV-F5G1,5L1=R, L2=s, L3=T, N=earth terminal, E=safety wire terminal1 2 34The connection cable must be secured in a strain-relief clamp.Caution!Remember to connect the safety circuit to the connection box terminal marked with . Theelectricity supply for the cooker must have a safety switch which enables the power to becut off in case of emergency. The distance between the working contacts of the safetyswitch must be at least 3 mm.Before connecting the cooker to the power supply it is important to read the information onthe data plate and the connection diagram.INSTALLATION8 9pan. For this purpose, adjustable feet