Q-See QC818 User Manual
Also see for QC-SERIES: User manualUser manualSetup guideQuick start guideUser manual
                                              | |
Contents
| 
72 73SETTING PRESET/PATROL/PATTERN/SCANClicking the Set button in the PTZ Control Panel (Picture 5-6) opens a new window inaddition to leaving the PTZ Control Panel active.This window allows you to set up the PTZ’s Preset, Tour, Pattern and Border functions.PresetSTEP 1. Start by using the eight direction arrows on the PTZ Control Panel (Picture5-6) to position the camera where you want.PICTURE 5-8STEP 2. Click the Preset button in theFunction list and enter the numberyou want to assign to this preset.To create another preset point, change thePreset Number and repeat steps 1 and 2.Your camera supports up to 255 PresetPoints. When you have created the desiredpreset points, you may use them to create atour.PAN/TILT/ZOOMPresetPatrol No.Set01Del PresetFunctionPresetTourPatternBorderPAN/TILT/ZOOMPresetPatrol No.Add Preset01Del PresetDel TourFunctionPresetTourPatternBorderPICTURE 5-9TourA tour is the sequence of points that yourcamera will move to automatically beforereturning to its starting point and repeating.You can create up to 8 tours.STEP 1. Click the Tour button in theFunction list and enter the numberof the preset you wish to add to it.STEP 2. Click Add Preset to enter itinto the tour. You can have up to 80presets in a single patrol.STEP 3. Assign the tour a numberYou can remove a preset point by clicking on the Del Preset button and an entire tour can bedeleted using the Del Tour button.PatternA Pattern is similar to a tour. However,instead of creating Preset Points, you movethe camera through the pattern you want it tofollow. You can create up to 5 patterns.STEP 1. Click the Pattern button in theFunction list.STEP 2. Click the Begin buttonSTEP 3. Modify the zoom focus andiris settings using the PTZ ControlPanel (Picture 5-6)PICTURE 5-10PAN/TILT/ZOOMPresetPatrol No.Begin01EndFunctionPresetTourPatternBorderPAN/TILT/ZOOMPresetPatrol No.Left01RightFunctionPresetTourPatternBorderPICTURE 5-11Border (Auto Scan)Using this feature will cause the camera to scan back and forth between two points. You cancreate up to 5 scans.In the PTZ Control Panel (Picture 5-6), clicking the PTZ Trace button will begin the autoscan. The button will convert to a Stop button which can be used to end the scan.STEP 4. Click the End button to save the changes.STEP 5. Enter the desired number for this pattern into the field.STEP 1. Click the Border button in theFunction listSTEP 2. Select either the Left or Rightbutton to indicate which edge you aredefining.STEP 3. Use the direction arrows in thePTZ Control Panel (Picture 5-6) tomove the camera to the limit desired.STEP 4. Repeat for the other border.IMPORTANT! If your NVR is set to record when motion is detected, themovement of your PTZ camera can create false alarms. You should adjust thechannel’s mode of recording as well as how it sends notifications to avoid this. |
Related manuals for Q-See QC-SERIES
manualsdatabase
Your AI-powered manual search engine