Configuring the InterfaceQMS 1725E Print System Getting Started4-10Configuring the InterfaceThis section describes the quick configuration procedure for theprinter interface. For a complete discussion of all of the configurationoptions available through the Administration/Communications/Crown-Net menu, see chapter 2, “Interface Configuration,” of theQMSCrownNet Interface System Administrator’s Guide.You can make these configuration changes through any of the follow-ing means:n Printer Control Panel—For information on using the printer con-trol panel to change configuration menu settings, refer to chapter4, “Printer Configuration,” of theReference guide.n CrownAdmin (for DOS, Macintosh System, or Windows) orCrownNet Manager for OS/2—For more information on usingthis software, refer to the appropriate chapter in the systemadministrator’s guide.» Note: CrownAdmin/CrownNet software is not available for the UNIXenvironment.n Remote Console—For information on accessing Remote Con-sole, refer to the appropriate chapter in the system administra-tor’s guide. For information on using Remote Console, refer to theQMS Crown Remote Console User’s Guide.EtherTalk1 If your network has more than one zone, use the Administra-tion/Communications/Network 2/CrownNet/EtherTalk/ZoneName/Zone Part 1 and Zone Part 2 menus to enter the nameof the zone to which the printer is attached.» Note: The two Zone Part x menus allow you to identify 1 zone with aname up to 32 characters long. (Up to 16 characters can be entered ineach of the two menus). You cannot use these two menus to identifytwo zones. Trailing spaces are not considered part of the zone name. Allstandard printable ASCII characters are valid except the @ and 'symbols.