QSC touchmix-30 pro User Manual

Also see for touchmix-30 pro: Quick start guide Technical notes User manual User manual Windows driver manual

Contents

QSC touchmix-30 pro User Manual Manual pdf 18 page image

101001108-01-Aired Connection to a Network or Router Using Automatic IP Addresses1. Use CAT-5 cable to, connect the TouchMix-30 ProEthernetport to a port on the network router.2. Mixer Name: When a wireless devices looks for a network, this name is displayed. You can change this name here.3. Edit Settings For: Wireless Wired4. IP Address Assignment: DHCP (Auto) Static DHCP (Auto)5. Touch Apply .Sound CheckBefore connecting anything, plug in your TouchMix-30 Pro and make sure that all the inputs and Auxiliary Outputs are muted. This will preventuncontrolled feedback if a microphone is patched into a hot channel.To Mute Channels:Inputs 1-8 Inputs 9-16 Inputs 17-24 Stereo In/2-Trk Aux Out 1-8 Aux Out 9-14Mute Mute Mute Mute Mute Mute Mute Mute Mute Mute Mute MuteIn each of the groups of faders, press the Mute button for each channel. Now you can connect the mixer to sources and speaker systems.Level-Match Your QSC SpeakersIf you’re using one of the following QSC Loudspeakers: OR your TouchMix-30 Pro tells you theoptimum input-gain setting for your loudspeaker.For Main L/R: Main Setup K SeriesFor Aux 1-8: Aux Out 1-8Aux 1 Setup K SeriesIn the popup all you need to do is touch the button associated with your loudspeaker, and then adjust your loudspeakers as instructed.You're probably wondering - why we recommend using input B. Input A has a switch that adds gain for use with a direct microphone input. If thisswitch is set incorrectly the speaker's input will be far too hot. Using input B eliminates the possibility of such a mistake.These settings will give you the optimum signal to noise performance and get the most from your QSC powered speakers. The mixer’s output meterswill reflect when you’re “running out of speaker”. Note that you will see the “Limit” light on your speakers illuminate as the mixer drives them harderduring louder portions. This is normal and is just the speaker’s internal DSP doing its job.Select a QSC E-Series VoicingQSC's PLD and GXD series amplifiers include voices for QSC E-Series loudspeakers. If you are using any other amplifier, E-Series voices may beapplied by the TouchMix-30 Pro.To load an E-Series voice: Aux Out 1-8Aux 1 PresetsFactoryE10 Dance XE10 Normal XE10 MonitorRecall