QSee QT SERIES User Manual
                                                                           | |
Contents
| 
124 125MOTIONMotion TabAs with the Alarm function above, it incorporates hold time and can trigger procedures.Select which cameras you wish to start recording on motion detection. Set the holding timewhich determines the length of time the cameras continue recording after motion stops.To Record allows you to determine which cameras will begin recording. Cameras canbe set to record individually, in blocks, or all cameras can be activated.To PTZ activates preset, cruise or track functions on selected Pan-Tilt-Zoomcameras. Depending on your model of PTZ camera, one of up to 128 pre-set actionscan be engaged. Check your camera’s manual for details.Schedule TabSet by default to always on, the schedule can be altered in the same manner as that used inSchedule in SECTION 4.4.PICTURE 8-6PICTURE 8-7PICTURE 8-8In the Trigger setting, you can set multiplechannels to record when motion is detectedby a camera that has been set to activateupon motion detection.For example: If Camera 1 detects motion,you can have it trigger Cameras 2 and 3 tobegin recording as well.In addition, the user can set the sensitivity of certain areas within the field of view by clickingon the Select button selecting the Area field for the respective camera.Specific areas can be made sensitive byapplying a blue grid to the desired section ofthe screen. The blue grid can be applied tothe entire screen – signifying that the entirefield of view is sensitive - by clicking onthe star button. The trash can button willremove the grid completely. Click and dragwith the mouse on the screen to draw orerase the grid in select areas. Sensitivity: 6Sensitivity: 6As sensitivity is influenced by color and light level, you can adjust its values according to yourspecific conditions. The default value is “4.” A setting of “8” is most sensitive while a setting of“1” is minimally sensitive.Right-clicking in the screen will show or hide the control menu at the bottom of the screen.VIDEO LOSSIn the event that signal is lost by one camera, others can be activated to record whileadditional devices can also be triggered.Test your settings by moving somethingor someone through the grid area in thecamera’s view. Motion should not be detectedoutside of this area but you should see ayellow humanoid figure appear in the screenonce the DVR detects movement within thegrid. Removing the grid where there is a flagor trees that frequently move in the wind willprevent false alerts. Click on the Disk buttonto save your settings before exiting the setupprocess by clicking on the X button.Schedule TabThis is also set to be on all the time by default and it can be adjusted in the same manner asthe Schedule configuration in SECTION 4.4.PICTURE 8-9PICTURE 8-10PICTURE 8-11PICTURE 8-12Like the Trigger tab in the Alarm Handlingsection of the Sensor menu, you can selectthe events that you wish to occur in theevent that a video input is lost. Both Alarmsand PTZ events can be scheduled as in theSensor menu above.OTHER ALARMIn this menu you can set the DVR to alert you to a full Hard Drive, IP Conflict on the network ora Disconnection.You can set the response as well as at whatthreshold of remaining disk space you wish tobe alerted.Sensitivity: 6Sensitivity: 6 |
Related manuals for QSee QT SERIES
manualsdatabase
Your AI-powered manual search engine