A–Simple Network Management ProtocolSNMP Trap ConfigurationISR654601-00 D A-3SNMP Trap ConfigurationSNMP trap configuration lets you set up to eight trap destinations. Choose fromTrap 1 through Trap 8 to configure each trap. Table A-2 describes the parametersfor configuring an SNMP trap.Table A-2. SNMP Trap Configuration ParametersParameter DescriptionTrap nenabledEnables or disables trap n. If disabled, the trap is not configured.Trap address* Specifies the IP address to which the SNMP traps are sent. A maximum of eighttrap addresses are supported. The default address for traps is 0.0.0.0.Trap port* Port number on which the trap is sent. The default is 162. If the trap destinationis not enabled, this value is 0 (zero). Most SNMP managers and managementsoftware listen on this port for SNMP traps.Trap version Specifies the SNMP version (1 or 2) with which to format traps.Table Note* Trap address (other than 0.0.0.0.) and trap port combinations must be unique. For example, if trap 1 and trap 2have the same address, they must have different port values. Similarly, if trap 1 and trap 2 have the same port value,they must have different addresses.
