2–Command ReferenceCommand Syntax2-12 ISR654601-00 DFcipRouteConfigures a new Fibre Channel over IP (FCIP) route and lets you modify ordelete an existing FCIP route.Each FCIP route requires a dedicated Fibre Channel and Gigabit Ethernet port.Configuring an FCIP route and specifying a Fibre Channel and Gigabit Ethernet(GE) port pair takes precedence over any previously existing configuration for theport pair (FC/GE), and removes the existing configuration of the port pair.Authority Admin sessionSyntax fciprouteaddmodrmKeywords addConfigures a new FCIP route.modModifies an existing FCIP route.rmRemoves an existing FCIP route.Notes You can also configure an FCIP route over a 10Gb Ethernet port, provided thatthe router has both an available 10Gb port and the FCIP 10Gb license installed.The same FCIP commands (fciproute add, fciproute mod, andfciproute rm, as well as show fciproutes) can be used to configure,remove, and view the FCIP route through a 10Gb Ethernet port. See the examplein the following.Examples The following shows an example of the fciproute add command:iSR6200 <1> (admin) #> fciproute addA list of attributes with formatting and current values will follow. Enter anew value or simply press the ENTER key to accept the current value. If youwish to terminate this process before reaching the end of the list press 'q' or'Q' and the ENTER key to do so.WARNING:The following command might cause a loss of connections to both GE ports.Configuring FCIP Route:-----------------------FCIP Interfaces FC & GE (0=Enable, 1=Disable) [Enabled ]
