ISR651101-00 E 7-17 Removal and ReplacementThis chapter describes how to remove and replace the following FRUs: SFP Transceivers iSR6200 Chassis Blades “Power and Cooling Modules” on page 7-10SFP TransceiversYou can remove and replace the SFP transceivers while the iSR6200 router isoperating without damaging the router or the transceiver. However, this interruptstransmission on the affected port until you install the transceiver. To remove a transceiver, gently press the transceiver into the port to releasethe tension, pull the release tab or lever, and then remove the transceiver.Different transceiver manufacturers have different release mechanisms.Consult the documentation for your transceiver. To install a transceiver, insert it into the port and gently press until it snapsinto place.iSR6200 Chassis BladesThe iSR6200 router provides an enhanced feature you can use to replace anyblade in the field. In a dual-blade chassis, the iSR6200 automatically restores areplacement blade’s configuration. When replacing a blade in a single-bladechassis, you can use the iSR6200 router’s management tools to save and restorea blade’s configuration.NOTE:The SFP transceiver fits only one way. If the SFP does not install undergentle pressure, flip it over and try again.
