3–InstallationInstalling the iSR6200 Router3-6 ISR651101-00 EInstalling the TransceiversThe router supports a variety of SFP transceivers. To install a transceiver, insert the transceiver into the port, and then gentlypress until it snaps in place. To remove a transceiver, gently press the transceiver into the port to releasetension, pull the release tab or lever, and then remove the transceiver.Different transceiver manufacturers have different release mechanisms.Consult the documentation for your transceiver.CAUTION! If the router is mounted in a closed or multi-rack assembly, the operatingtemperature of the rack environment may be greater than the ambienttemperature. Be sure to install the chassis in an environment that iscompatible with the maximum rated ambient temperature. Do not restrict chassis air flow. Allow 16cm (6.5 inches) minimumclearance at the front and rear of the router (surface mount) or rack forservice access and ventilation. Multiple rack-mounted units connected to the AC supply circuit mayoverload that circuit or overload the AC supply wiring. Consider thepower source capacity and the total power usage of all routers on thecircuit. Reliable grounding in the rack must be maintained from the routerchassis to the AC power source.NOTE:The transceiver fits only one way. If the transceiver does not install undergentle pressure, flip it over and try again.
