Quadra-Fire 31I-ACC Owner's Manual

Also see for 31I-ACC: Installation manual Owner's manual Installation manual Owner's manual Owner's manual

Contents

Quadra-Fire 31I-ACC Owner's Manual Manual pdf 21 page image

November 21, 2011 7044-140C Page 213100-I ACC Wood InsertR5 Service Parts ReplacementA. Glass Replacement(Replace with 5mm ceramic glass only)1. Ensure that the fire is out and the appliance is cool tothe touch.2. Protect a table or counter top with padding or towels.Protect your hands and wear gloves to prevent injury.3. Remove the door with the broken glass by lifting thedoor up and off of the hinges.4. Lay door face down on a table or counter making surethe handle hangs over the edge so the door lays flat, ona soft surface.5. Remove the screws from each glass retainer and removethe glass. (If screws are difficult to remove, soak withpenetrating oil first).6. Center the glass with edges evenly overlapping theopening in the door, (i.e. same space top and bottom,left and right sides).7. Replace the glass retainers. Be careful not to crossthread the screws.8. Tighten each retainer just a few turns until each issecured. Check again for centering of glass in doorframe. Continue to tighten each retainer alternately, afew turns at a time, until the glass is secure. DO NOTOVERTIGHTEN - can cause glass to break.9. Replace the door on the appliance.Quadra-Fire appliances are equipped with ceramic superheat-resistant glass, which can only be broken by impact ormisuse.WARNING! Risk of Fire or Injury!Use only glass that is specified in the manual, DO NOTreplace with any other material. Glass breakage will occur.CAUTION!Handle glass with care.• Inspect the gasket to ensure it is undamaged.• Do NOT strike, slam or scratch glass.• Do NOT operate appliance with glass & door assemblyremoved.• Do NOT operate with glass cracked, broken orscratched.B. Snap Disc ReplacementMagnetSpadeConnectorsSnap DiscFigure 21.1 Snap Disc Location1. Locate the snap disc bracket assembly at the bottom leftrear corner of the appliance. Figure 21.12. A magnet holds the bracket to the appliance. Pull thebracket down away from the appliance to expose the snapdisc.3. Pull the snap disc and spade connectors up and out ofbracket as shown in Figure 21.2.4. Using a Phillips head screw driver, remove the 2 screwsfrom the snap disc and then remove the snap disc fromthe spade connectors. Replace with new snap disc andre-connect to spade connectors.5. Push the snap disc and spade connectors back insidebracket and re-attach the bracket to the appliance.Figure 21.2Snap Disc