Quadra-Fire 31I-ACC Owner's Manual

Also see for 31I-ACC: Installation manual Owner's manual Installation manual Owner's manual Owner's manual

Contents

Quadra-Fire 31I-ACC Owner's Manual Manual pdf 39 page image

November 21, 2011 7044-140C Page 393100-I ACC Wood InsertRC. Securing Stove Pipe/Liner to Flue Collar1. There are 4 pre-drilled holes in the flue collar 90 degreesapart. Attach the flue collar to the stove pipe/liner. If theseal is questionable use stove mastic Figure 39.1.2. Attach gasket to bottom side of flue collar with a thin coatof silicone.Flue Collar Stove Pipe/LinerGasketFigure 39.1Figure 39.2Figure 39.3Figure 39.4D. Optional Offset Adapter InstallationIn some installations the flue collar and stove pipe/liner donot always align properly. This situation may be remediedby using the optional offset adapter. See Appliance Dimen-sions page for the amount of distance this accessory cantelescope between the flue collar and stove pipe/liner.1. Remove the cast iron flue collar from the appliance andflip it upside down. Using the larger #7 drill bit supplied,drill through all 8 countersunk locations. Figure 39.2.2. Slide the gasket over the the flue collar and attach it to theoffset adapter using the 8-32 flathead screws provided.Figure 39.3.3. Adjust the offset adapter to desired distance. Drill holesthrough the lower chamber as shown in Figure 39.4 usingthe small drill bit #26 provided.4. Cut the gasket to the proper length and slide in betweenthe upper and lower chambers centered on the screwholes. Attach the upper and lower chambers with screwsprovided. Figure 39.5.5. Repeat the process on the bottom side.Cast Iron Flue Located on ApplianceDrill through all 8 countersunklocationsOnce distance is established, drill holesand secure both chambers together.Figure 39.5