Quadra-Fire QV32E-B Owner's Manual

Quadra-Fire QV32E-B Owner's Manual Manual pdf 14 page image

Quadra-Fire • Village Collection Electric Fireplace • 4030-782 Rev D • 11/05147 Heater SetupGrate placement holesLog tabsFigure 7.3 Install GrateA. Remove Shipping Materials• Remove shipping pack from front of fireplace taking carenot to damage grate. See Figure 7.1.• Remove grate from shipping pack and set aside. Discardshipping pack.• Cut and discard the ties bundling the firescreen.• Remove screws holding ember bed shipping tabs inplace.• Remove the tabs and discard. Replace the screws.B. Clean HeaterThe heater was cleaned at the factory but dust may haveaccumulated during shipping.• Vacuum firebox area and wipe acrylic panel (in back offirebox) with a dry, lint-free cloth or paper towel. DO NOTUSE GLASS CLEANER! It will ruin the acrylic panel.• Remove all fingerprints and smudges from front trim toavoid permanently burning them into finish.C. AccessoriesRefer to instructions included with accessory.D. Install RefractoryRemove protective cover to access final installation items.Remove Log AssemblyLift log set straight up and place in safe place.Install Side Refractory• Remove the refractory and fasteners from the carton.• Take the refractory support bracket and bend it until it isL-shaped.• Install the bracket to the underside of the firebox top usingthe screws provided. Keep the bracket loose to allow therefractory to slide in behind it.• Tilt the side refractory into the heater and slide it behindthe bracket. See Figure 7.2.• Tighten the bracket when the refractory is resting on thehearth and is up against the back acrylic panel.• Repeat for the other side.Install Grate• Place grate legs into corresponding holes in ember bed,andirons to front. See Figure 7.3.Reinstall Logs• Slide log brackets over tabs located on back of emberbed. See Figure 7.4.Figure 7.2 Sliding Side Refractory Behind Bracket(right side shown)Figure 7.4 Install LogsFigure 7.1 Shipping Pack