Page 36 7063-173D November 22, 2011RVOYAGEUR Wood InsertUL 1777 Insulated Stainless SteelLiner or Other Approved Lining SystemFollow Manufacturer’s Instructionson Insulation and SupportFor Zero or Other Non-Code Clearances,Follow Approved Liner Manufacturer’s SpecificInsulation Requirements: Different ClearancesMay Require Different SpecificationsMasonry Chimney MustHave Structural IntegrityUL 1777 Insulated Stainless SteelLiner or Other Approved Lining SystemMinimum 8 in. (203mm) MasonryThickness in Front of Smoke ChamberDamper Plate Removed orFastened in Open PositionSeal with Non-Combustible MaterialMinimum Clearance in Accordancewith Insert ListingFloor Protection inAccordance with InsertListingFollow Manufacturer’sInstructions for MaximumLiner Extension AboveChimneyMaximum 30 DegreesOffset in ChimneyCombustible FloorMasonry Chimney (Cont’d)Figure 36.1 - Masonry Chimney with a Full Liner Kit Type UL103HT Rquirement per UL1777NOTE: In Canada, this fireplace insert must be installedwith a continuous chimney liner of a 6 inch (152mm) diam-eter extending from the fireplace insert to the the top of thechimney.The chimney liner must conform to the Class 3 require-ments of CAN/ULC-S635, Standard for Lining Systems forExisting Masonry or Factory-Built Chimneys and Vents,or CAN/ULC-S640, Standard for Lining Systems for NewMasonry Chimneys.This insert conforms with the UL 1482 and ULC S628(Canada) in all respects, and is approved to UL & ULCsafety standards for installation and use within a fireplacewith a masonry chimney in accordance with NFPA 211 andCAN/CSA-B365-01.NOTE: Generic wood insert shown - not model specificIn USA a minimum 5 foot length, 6 inch diameter flueliner is required as per UL 1482, however Hearth &Home Technologies strongly recommends a full relinefor optimum performance.