Quadra-Fire VOYAGEUR-MBK Owner's Manual

Also see for Quadra-Fire VOYAGEUR-MBK: Owner's manual Installation manual Installation manual Owner's manual Installation manual

Contents

Quadra-Fire VOYAGEUR-MBK Owner's Manual Manual pdf 44 page image

Page 44 7063-173D November 22, 2011RVOYAGEUR Wood InsertI. Blower Cord Installation on Left SideThe blower cord is shipped to be installed on the right sideof the appliance. You may relocate the cord so it is on theleft side.Overview: You are removing the power cord from theblower controls, re-routing the cord to the left side and re-installing the power cord to the blower controls. Refer tothe exploded drawing on page 45.1. Remove contents from box being careful not to scratch ordamage the cast trim pieces.2. Lay surround pieces face down on a protected surface toprevent scratching.3. Align the bosses on the top piece to the holes on the sidepieces. Secure the 3 pieces together.4. Attach the mounting brackets to the side pieces included withthe kit. Figure 44.1.5. In order to get a tight seal for the surround, you must repositiona side shield. There are two holes on the shield and it will comefrom the factory secured in the first (left) hole. Remove theshield and re-install using the second (right) hole. Figure 44.2.5. Position the trim on the appliance matching up the mountingbrackets with the slots on the appliance.6. Attach the surround to the appliance 2 screws.DO NOT OVERTIGHTEN SCREWS - MAY DAMAGEPROCELAIN FINISH.Included in Surround Kit: (2) side pieces, left and right; (1)l top piece; (1) fastener package.Tools Needed: Powered 4 to 6 inches long Phillips headscrew driver; pliersH. All Cast Surround Kit4 Mounting BracketsMountingBracketsAttach to Appliancewith ScrewsRemove and RepositionSide Shield using SecondHoleDo not overtighten - maydamage porcelain finishFigure 44.1Figure 44.21. Swing the grille down to expose the 2 bolts, oneat each end. Remove the bolts and pull bloweraccess assembly away from appliance and storeaway from your work area.2. Remove the 2 screws in the hold down bracket infront of the blower assembly. You do not need toremove the blower from the hold down bracket.3. Disconnect the 2 blower wires that are attachedto the wire harness and pull the blower assemblyaway from the appliance.Figure 44.3Figure 44.4Size: 40 in. W x 30 in. H