Chapter 3 Changing the Library ConfigurationSetting the Library IDSun StorEdgeô L25 Tape Library and Sun StorEdgeô L100 Tape Library Userís Guide 55Setting the Library ID 3By default the library SCSI ID is set to 0. To change the library SCSIID setting:1 Access the Configuration screen (see Accessing theConfiguration Screen).2 Press the Up or Down buttons until Library ID is highlighted.3 Press Select.4 Use the Up or Down buttons to select the desired SCSI ID.Available settings are 0 through 15.5 Press Select.To return to the Configuration screen without changing theoption setting, press Cancel.6 Press Main to return to the main screen.Caution: If you do not return to the main screen afterchanging this setting, your change will not besaved to NVRAM.Note: You must reboot the library before this setting willtake effect.
