Quantum ValueLoader User Manual
Also see for Quantum ValueLoader: Warranty
                                                                                          | |
Contents
| 
ValueLoader AdministrationRunning the ValueLoader System TestValueLoader LTO-1/LTO-2 Tape Autoloader User Manual 41Running the ValueLoader System Test 3The System Test option cycles the ValueLoader through the process ofloading, calibrating, and unloading all cartridges in the carousel.Running a System Test verifies the operational soundness of both theValueLoader and tape drive. The System Test continues indefinitely untilyou press the [Cancel] button. All regular backup and restore operationsare suspended while a System Test is in progress.To run a System Test:1 From the Home Screen or main menu, press the [+] or [-] button untilDiagnostics appears on the top line of the LCD screen.2 When System Test appears on the LCD screen, press the [Enter] buttonto begin the test.The Test Count displays the number of load-unload cycles that havebeen completed during the test.3 Press the [Cancel] button to end the test.Retrieving Information About the ValueLoader 3The Information menu provides access to information about theValueLoader, including the cycle count, event log, and firmware revision.Cycle Count 3 This option displays the total system cycle count, incrementing each timea tape is loaded into the drive or exported from the ValueLoader.To use this option:1 From the Home Screen or main menu, press the [+] or [-] button untilInformation appears on the top line of the LCD screen. Press the [Enter]button to access the available options.Note: At least one cartridge must be present in the carousel in orderto run System Test. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine