Quicksilver 810 Arvor Owner's Manual

Quicksilver 810 Arvor Owner's Manual Manual pdf 34 page image

Quicksilver 810 Arvor — System & Component Overview and Operation22Fuel burning open flame appliances consume cabin oxygenand release products of combustion into the craft.Ventilation is required when appliances are in use. Opendesignated vent openings while appliances are in use. Donot use the stove or oven space heating. Never obstructventilation openings.Do not use solutions containing Ammonia Never use flames to check for leaksDo not smoke or use open flame when replacing LPGcylinders. Close cylinder valves on empty cylinders beforedisconnecting for replacement.Ensure that when the LPG stove is on, avoid contact ofmaterials to the open flame. Never leave craft unattendedwhen open flame LPG consuming appliances are in use.System Leak TestPrior to the boat leaving the factory, the LPG system is tested for any potential leaks. However,Quicksilver® recommends that you test the system regularly. Test all connections for leakage bymeans of the following:1. Before each use, close appliance valves; open LPG cylinder valve; allow indicated gaugepressure to stabilize; close LPG cylinder valve; observe pressure gauge reading near cylindervalve for three minutes; pressure gauge reading should remain constant if no leak in thesystem is present. IF PRESSURE GAUGE READING FALLS, LEAK IS PRESENT. DO NOT USE LPGAPPLIANCES.2. Routine observation of bubble leak detector (if fitted on the system).3. Manual leak testing with foam-producing, soapy water or detergent solutions (with applianceburner valves closed and cylinder and system valves open); foam-producing solutions for leakdetection on gas installations in accordance with EN 14291 meet these requirements.If a leak is present, shut off the LPG supply at the main supply valve. Extinguish any open flames(heaters, stoves, etc.) and do not operate any electric switches. Finally, evacuate the area if possible.Quicksilver® recommends that any LPG system repairs should be made by your authorizedQuicksilver® dealer.Do not use an LPG system that has leaked until it has beeninspected and repaired by a competent person.If a leak is detected, shut off the main LPG supply valve anddo not use LPG appliancesChanging LPG CylindersTo replace empty LPG cylinder:1. Turn off the stove and close the shutoff valve.2. Close the valve on the LPG cylinder.3. Remove the regulator by turning the nut clockwise.4. Replace the empty tank.5. Inspect the regulator. Make sure that the gasket located on the regulator nut is in goodcondition. If not, replace regulator gasket or regulator itself.6. Re-install and tighten the regulator by turning the nut counterclockwise.7. Check for any leaks before restarting the stove.9. Bow Anchor WindlassThe anchor windlass located at the bow of the boat assists with the anchoring of your boat byautomatically raising and lowering the anchor. The windlass is operated from the helm.