Q-Drive Installation Manual Issue 1.5Page ii Copyright © 1996 Quin Systems Ltd.7. Drive Parameters 337.1 Serial Link 337.2 Getting Around the Configuration Program 337.3 Page 0 Parameters 367.4 Page 1 Parameters 377.5 Page 2 Parameters 397.6 Page 3 parameters 417.7 Page 6 parameters 417.8 Page 8 parameters 427.9 Page 9 parameters 437.10 Status & Alarm page 448. Switching On 478.1 Switching the Servo-Amplifier On Without a Motor 478.2 Checking LEDS and 7 segment display 478.3 7 segment display on the front panel 488.3.1 Checking the electrical rotation sense of the resolver 498.4 Determining the motor phases 508.5 Switch the Servo Amplifier on with a Motor and Optimization 518.5.1 Preparation before switching the mains voltage on 518.5.2 Switching the mains voltage on 518.6 Compensating the speed controller 528.6.1 Offset and speed compensation 528.7 Trouble Shooting 549. Testing the System 559.1 General 559.2 Serial port 559.3 Resolver Interface 559.4 Encoder Simulator 5610. Configurations 5710.1 General 5710.2 Resolver Ratio 5710.3 Amplifier Configuration 5810.4 Servo-amplifier fuses 5810.5 Backplane configuration 6010.6 Backplane Fuse 6211. Options List 63
