RAMSET RAM 100 Instruction Manual

Also see for RAM 100: Instruction manual

RAMSET RAM 100 Instruction Manual Manual pdf 16 page image

14RAMSETwww.ramsetinc.comRAM 100 • 1000 • 5500LED # FUNCTION STATUS RESULTS TROUBLESHOOT1 Power ON 18-24V AC/DC Present Check 115VAC, Check 3A Fuse, Check TransformerOFF No input power3-4 Motor 1 & 2ON Motor is running Check 15A SB fuse, Check 115V AC, check motor over-load button (red)OFF Motor is stopped5-11Accessories (Safety, Close,Firebox, Exit, Phanton, Radio,EdgeON Triggered by Accessory Disconnect the accessories, if LED goes 'off' then acces-sory is bad or not properly alignedOFF Normal status12-13 Limit 1 & 2 ON Gate is on a limit Check limit switch & wiringOFF Gate is in between limits14-16 Opening, Stop, Closing ON One of these LEDs is always 'on'. Gate is eitheropening, closing or stopped. If LEDs 14, 15 & 16 are all OFF, then the control boardneeds to be repaired/replaced.OFF ---17 CommunicationON Blinks when processing signals If LED is always 'on' or never 'on' then control boardneeds to be repaired/replaced.OFF ---18 Mag LockON Energizes mag lock when closing or closed. If not energizing when lit, check mag lock transformer,voltage on mag lock & mag lockOFF De-energized when gate is opening or opened.19-20 Full Open, Full Closed ON Gate is on a limit Check dip switch A4, make sure the chain was connectedin the right positionOFF Gate is inbetween limits21 Pre Warn & Constant Warn ON Relay for pre warn or constant warn is active Make sure dip switch B1 or B2 is 'on'. Make sure analarm/light has been added to the relay connections plugOFF Pre warn & active warn is not active22 3-Button Stop or Foot PedalSwitchON Either the 3-button stop or foot pedal switch is beingtriggered Check foot pedal switch & stop button on JP3 & JP11.Check S7 configuration.OFF Normal status23-24 3-Button Open, 3-Button Close ON 3-button is triggering the open or close Check the 3-button station or anything connected to JP3.OFF Normal status25 Monitored Anti- EntrapmentDeviceON Anti-entrapment device is being triggered ordisconnected Make sure all 5 wires are correctly connected to JP13.Make sure the anti-entrapment device is working andaligned.OFF normal status26 Slow Down ON Gate is in slow start/stop mode Check dip switch C2.OFF Slow down mode is turned offINTELLIGATE LED LAYOUT