GB - 24Use Default Settings1. Press the SETUP button in stop mode.2. Press the / button to select Misc.3. Press the button, then press the / button to select“Use Default Settings” dialogue box.4. Press the ENTER button, then press the / button toselect “Yes”. Press the ENTER button and the originalsetting will be restored. The unit will exit setting menuautomatically and re-load the disc in the disc tray.Note: It will take 3-5 seconds to reset the DVD player to thefactory default.Screen Saver1. Press the SETUP button in stop mode.2. Press the / button to select Misc.3. Press the button, then press the / tcelesotnottubScreen Saver.4. Press the ENTER button, then press the / button tochange the On/Off mode.5. Press the ENTER button.6. Press the SETUP button or RETURN button to exit themenu.MISCCUSTOMIZING THE FUNCTION SETTINGSCleaning the DiscA defective or soiled disc inserted into the unit can cause sound to drop out during playback.Handle the disc by holding its inner and outer edges.• Do NOT touch the surface of the unlabeled side of the disc.• Do NOT stick paper or tape on the surface.• Do NOT expose the disc to direct sunlight or excessive heat.• Clean the disc before playback. Wipe the disc from the center outward with a cleaningcloth.• NEVER use solvents such as benzine or alcohol to clean the disc.• Do NOT use irregular shaped discs (example: heart shaped, octagonal, etc.). They may causemalfunctions.Cleaning the Unit• Be sure to turn the unit off and disconnect the car power adapter before maintaining the unit.• Wipe the unit with a dry soft cloth. If the surfaces are extremely dirty, wipe clean with a cloth that has beendipped in a weak soap-and-water solution and wrung out thoroughly. Then wipe with a dry cloth.• Never use alcohol, benzine, thinner, cleaning or other chemicals. Do NOT use compressed air toremove dust.Important Note• Before transporting the unit, remove any disc from the disc compartment.MAINTENANCEDo you want to use default setting ?