RCA HD52W58 User Manual

Also see for HD52W58: Technical specifications

Contents

ReferencesChapter 5 61Blank screen• Make sure you have connected the component to the TV correctly.• Make sure the component connected to the TV is turned on and tuned to the corresponding Video InputChannel.• Try another channel, or press the INPUT or ANT•CAB button.Unusual sound quality• Check the Graphic Equalizer, SRS, and Sound Logic settings.• Check if SAP is turned on.• Check that the Audio Mode is set to your language.Humming or buzzing noise• Maybe the speakers are turned off. Check the FIXED/VARIABLE OUT control panel in the Audio menu.No sound, picture okay• Maybe the sound is muted. Try pressing the volume up button to restore sound.• Maybe the speakers are turned off. Check the FIXED/VARIABLE OUT control panel in the Audio menu.• If using an S-Video connection, component video and composite video, remember to also connect thecomponent’s L and R AUDIO OUT jacks to the TV’s L and R INPUT jacks.• Check the Maximum and Initial Volume settings in the Special Features menu.Channel search finds few channels• The cable connected to the CABLE and/or ANTENNA INPUT jack might be loose.• Your off-air antenna might be getting a weak signal. Move it higher or get a bigger antenna.• If you have cables connected to the CABLE and ANTENNA jacks, try swapping the cables. Cable needs to beconnected to the CABLE INPUT; off-air antenna needs to be connected to the ANTENNA INPUT.• If you have a cable box, you can’t connect it to the ANTENNA jack. Connect it to the CABLE INPUT or a VideoInput jack.• Select all the options in the Channel Search menu, and retry channel search.Can’t select certain channel• May be blocked or not approved in the Parental Controls menu.• If using a VCR, check to make sure the TV/VCR button on the VCR is in the correct mode (press the TV/VCR orINPUT button on your VCR).• You usually can’t change channels when a menu is on the screen (press the CLEAR button).Noisy stereo reception• May be a weak station. Use Audio menu to choose Mono sound.No picture, no sound but TV is on• Maybe the cable/antenna option wasn’t chosen in the Channel Search menu. Select Detect antenna or cablesetting in the Channel Search menu and run the search again.• The channel might be blank — change channels.• If you’re watching your VCR and it’s connected with coaxial cable to the CABLE/ANTENNA jack, tune the TV tochannel 3 or 4 (whichever channel is selected on the 3/4 switch on the back of your VCR). Also check to makesure the TV/VCR button on the VCR is in the correct mode (press the TV/VCR button on your VCR).• If a channel doesn’t exist and you tune to scrambled QAM channel, Unusable Signal appears.