RDM EC9001f User Manual
Also see for EC9001f: User guide
                              | |
Contents
| 
EC9000i Series Scanner User Guide Setting up your scannerConnecting the power cord1. Align the flat side of the power connector so that it is facing up.2. Insert the round end of the power cord into the power port on the back of the scanner.When the cord is pushed in completely, it clicks into place.3. With the power cord connected to the power adapter, plug the other end of cord into a poweroutlet.Disconnecting the power cordCaution: Disconnecting the scanner from a power source while the scanner is processing a transactionmight cause data loss.The power cord has a sleeve on it that secures it to the unit. The security sleeve prevents the power cordfrom being pulled out of the unit accidently.1. Hold the unit in place with one hand to prevent the unit from falling.2. With your other hand, slide the power cord security sleeve back and pull the power cord free ofthe scanner.Drivers and ApplicationsThe drivers for your scanner are installed on your computer when you install the check scanningapplication. There are many applications that support the RDM EC9000i scanner. Most are available fromthird-party vendors.If you are not sure where to acquire your check scanning application, check with whoever provided yourscanner.©2014 RDM Corporation Page 19 |
Related manuals for RDM EC9001f
manualsdatabase
Your AI-powered manual search engine