MEDIA BAY AND RED MINI-MAG ISSUESSYMPTOMSLEDs on media bay do not illuminate when expected.RED MINI-MAG does not mount to camera.POTENTIAL RESOLUTIONSEnsure RED MINI-MAG is fully inserted in the media bay.Perform a system restore.Reformat the RED MINI-MAG on the computer. For more information, see the DSMC Media Operation Guide atwww.red.com/downloads.Remove and reinstall the media bay. For more information, go to "Remove the Media Bay" below.REMOVE THE MEDIA BAYTo troubleshoot issues with the media bay or SSD, you may need to remove and re-install the media bay. Unless youare troubleshooting media-related issues, DO NOT remove the media bay.WARNING: Before installing or removing the media bay, you MUST turn off the camera.REQUIRED TOOLS: T10 TORX driver1. Turn off the camera.2. Loosen the four (4) captive screws in a cross pattern (“X” pattern) using a T10 TORX driver.3. Remove the media bay from the camera.4. Inspect the connections and pins on the camera and ensure that they are clean and undamaged.NOTE: DO NOT touch any part of the exposed boards or connectors.5. Re-attach the media bay as soon as possible to prevent dust or debris from entering the camera. For moreinformation, go to "Install the Media Bay" below.INSTALL THE MEDIA BAYWARNING: Before installing or removing the media bay, you MUST turn off the camera.REQUIRED TOOLS: T10 TORX driver1. Turn off the camera.2. Place the media bay on the camera, so that the mounting holes of the media bay align with the screw holes of thecamera.3. Use a T10 TORX driver to tighten the four (4) captive screws by about two (2) turns in a cross pattern (“X” pattern).DO NOT FULLY TIGHTEN.4. Tighten the four (4) captive screws evenly. DO NOT exceed 70 in-oz, or damage may occur.WARNING: DO NOT OVERTIGHTEN.C O PYR I G HT © 2017 R ED.C O M , I NC 955- 0127_V6.3, R EV- M | 183RED RAVEN OPERATION GUIDE