RED RAVEN RED DRAGON 4.5K Operation Manual
                                                                                                                                                                                                                                      | |
Contents
| 
C O PYR I G HT © 2017 R ED.C O M , I NC 955- 0127_V6.3, R EV- M | 36RED RAVEN OPERATION GUIDE3 BASICOPERATIONSPOWER OPERATIONSThis section describes the basic power operations of the camera system.For more information, see the DSMC Power Operation Guide, available at www.red.com/downloads.NOTE: Modules and expanders are NOT HOT SWAPPABLE, meaning you cannot remove or install these items whilethe camera is turned on. Before installing or removing these items, you MUST turn off the camera. Failure to do somay result in damage to the item or camera that is not covered under warranty.WARNING: While third-party batteries may be mechanically compatible with the camera system, the manufacturer isresponsible for the performance and stability of third-party options, not RED®. Damage to the camera system or third-party devices caused by using third-party power options is not covered under warranty. The camera may be unable todetermine and display the voltage or remaining battery capacity of third-party power options.POWER PRIORITYWhen multiple power sources are connected to the camera, power consumption is prioritized in this sequence:1. Any power supply connected to the DC IN port on the expander2. Any power supply connected to the DC IN port on a rear battery module3. Rear battery4. REDVOLT battery in the DSMC2 REDVOLT ExpanderPOWER CONSUMPTIONThe camera draws approximately 3.3 A (50 W) when configured with the DSMC2 Base Expander, DSMC2 RED Touch7.0" LCD, and RED MINI-MAG® 512GB.Under typical conditions batteries provide the following operating time:REDVOLT: Powers the camera and accessories for approximately 30 minutes.REDVOLT XL: Powers the camera and accessories for approximately 90 minutes.RED BRICK: Powers the camera and accessories for approximately 120 minutes.POWER STATUSThe power status of the current primary power source displays in the Lower Status Row of the graphical user interface(GUI). Navigate to the Power In menu at Menu > Power > Power In for the status of all connected power sources.For more information, go to "Power Menu" on page 132. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine