Racelogic DriftBox Instruction Manual

Contents

Racelogic DriftBox Instruction Manual Manual pdf 24 page image

Racelogic Ltd Lap Timing ModePage 24Split OutputSimilar to the Laptime Telemetry option, this enables split time data or a 250ms pulse tobe output via the telemetry serial port whenever a split line is crossed. The output givenwill be the same type as the lap timing output, so if you have enabled Laptime Telemetrythe split output will be in the Telemetry format; if you have enabled Laptime Pulse the splitoutput will be in the Laptime Pulse format. If this option is disabled, no output will be given.Start / finish and split linesBefore DriftBox can measure and display times, you will need to either load previouslyrecorded start / finish lines or create new ones in your DriftBox.Setting start / finish lines• Press the MENU button to display the Lap Timing Menu.• Highlight ‘SET START & SPLITS’ and press OK• As you drive across the start / finish line press OK• This will set the start / finish line and the screen will now show the SET SPLIT1screen.• To set the first Split, press OK when you pass this point or press RESET to skip.• If you wish just to place a separate Finish line, press the ‘RESET’ button to skip allthe split points and scroll to the SET 2nd FINISH screen.• Press OK to set a separate finish line as you drive over it.Note: you must be moving to be able to set virtual lines.Saving start / finish and Split LinesAfter creating start / finish, Splits or Finish lines you can save them to a file on the SD cardwhich can be loaded back into DriftBox at a later stage, or used in the DriftBox Toolssoftware. The file created on the SD card is an ‘.dsf’ file.To Save the lines you have created:• Ensure the SD card is inserted.