Racelogic DriftBox Instruction Manual

Contents

Racelogic DriftBox Instruction Manual Manual pdf 51 page image

Racelogic Ltd DriftBoxTools SoftwarePage 51Displaying Drifting resultsTo extract and display Drifting results from a file press the Drift Mode buttonin the Graph screen toolbar. This causes the software to scan the loadedfile and apply loaded sector file information to produce a Drifting data gridshowing the following data:• Peak Drift angle• Peak G• Average G• Average SpeedA G meter and Drift meter window also appear when the Drift Mode button is pressed.When the replay facility is used to replay the loaded file, the G and Drift angle windowsdisplay data from the file that corresponds to the cursor position as it moves through thereplaying data.Displaying Drifting Data from a Logged file.• Click the Load all button to load a DriftBox file into the DriftBoxTools software.• If you don’t have a sector file relevant to the logged data then you will need tocreate one. See the Graph screen chapter for full instruction of this process.• Press the Drift Mode button to scan the file and display results.Displaying Lap TimesTo display the lap times press the Lap Timing button in the Graph screentoolbar. The software scans the currently loaded file and extracts lap timesand Vmax for each logged lap and displays the data in a Lap timing window.Make sure you have already defined a start / finish line.Including Split timesClick on the right hand arrow on the Lap timing button, then from the drop down menuselect ‘Lap timing with Splits’. Then if you have split lines defined the table will show thesplit times as well as the Lap times for you file.Loading and comparing individual laps in the Graph screenIndividual laps from the loaded file can be compared to each other in the graph screenwindows. Each lap shown in the Lap timing table has a Graph Icon associated with it in theright hand column. Clicking one of these buttons allows that run to be graphed: