Program Mode 19In addition to calibration, authorized users may change the monitorsettings to their requirements using the Programming Mode.NOTE: Monitoring gas concentrations continues during ProgrammingMode, but pauses during Calibration. Datalogging also pauses duringProgramming Mode, but resumes when programming is finished.Pressfor desired menuto answer “no”to decrease a digitPressfor desired submenuto answer “yes”to increase a digitPressto return to the sensor name/instantaneous reading displayto exit a submenuto advance digitsTo enter the Program Mode, press M and [N/-] together until the firstprogram menu appears: “Calibrate Monitor?” Refer to Getting Started onpage 5. The figure on the following page summarizes the programmingmenus and how to navigate through them.Programming ModeY/+N/-MODEN/-MODE
