Rangemaster KITCHENER U109720 - 01 Installation And User Manual

Also see for Kitchener 90 Electric: Installation and user guide User's guide & installation instructions

27WARNING - SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSONDisconnect from electricity before servicing. Check appliance is safe when you have finished.12. To Change Main Oven Door LatchRemove outer door panel (see 15). Remove screws ‘B’holding latch assembly to inner door panel. Fit new catchand reassemble in reverse order.Check correct door operation.13. To Change Oven Door SealOpen oven door. The seal is held in place by small hooks onthe rear face. At the corner pull seal diagonally away fromthe door centre until that hook is released. Proceed to thenext hook and release it in a similar way, and so on. Useforce if the hooks are stiff, as the old seal will be discarded.When fitting new seal, position the seal join at the bottom.Hook the new seal in one of the corner holes of the door,and proceed round the door snapping in each hook in turn.14. To Adjust Main Oven Door Catch KeepOpen oven door, slacken off locknut at base of keep, andscrew in or out as required until required fit is obtained.Retighten locking nu6. To Remove a ThermostatDisconnect from the electricity supply.Remove control panel and hotplate (see 1 & 2). Openoven door. Remove oven furniture and slide out ovenroof liner if fitted.Left hand ovenPull cooker forward to gain access to the cover boxat the rear of the cooker. Remove the four screwssecuring the cover and lift clear. The oven thermostatcapillary is clamped to the oven back sheet with anearthing plate. Remove the screws and plate.LH ovenPull cooker forward to gain access to the coverbox at the rear of the cooker. Remove the screwssecuring the cover and lift clear.Feed the thermostat capillary out of the oven. Disconnectwiring from thermostat. Remove 2 screws holdingthermostat to mounting panel. Fit new thermostat andreassemble in reverse order. Ensure that the phial is clippedto the oven back with the phial centrally positionedbetween the clips.Check operation of thermostat.8. To Change Grill ControllerLift up the ceramic hob top (see 2). Remove controlpanel (see 4). Disconnect wiring from controller. Remove2 screws holding controller to mounting panel. Fit newcontroller and reassemble in reverse order. Check for correctoperation.9. To Remove Grill DoorRemove the left hand side panel (see 1). Remove the controlpanel (see 4). Remove the centre cover strip (5 screws, 2 top,2 bottom, 1 in middle). Remove the two countersunk screws(1 each side) securing the grill hinge arms to the front of thegrill chamber.NOTE: The arms are spring tensioned. Carefully remove thegrill door. Retain the gaskets.Reassemble in reverse order ensuring that the gasket isfitted between the hinge arm and the front of the grillchamber.10. To Remove Main Oven DoorOpen oven door and remove Handyrack (where fitted)by springing one side out of the bracket on the door andsliding the other side free. Support the door and removethe two screws securing the upper hinge and packing tothe cooker front. Remove the door from the lower hinge bylifting slightly and moving outwards.Reassemble in reverse order.11. To Change Main Oven Door Outer PanelMove the cooker forward to gain access to the sides.Open the oven door slightly and remove the front panelfixing screws from the door sides (two each side).Carefully lift off the outer door panel.Remove door handle from panel by unscrewing 2 retainingnuts. Fit door handle to new panelFit panel to door. Reassemble in reverse order.