Rangemaster Professional + 100 User's Manual & Installation Instructions

Also see for Kitchener 100: User's guide & installation instructions

Rangemaster Professional + 100 User's Manual & Installation Instructions Manual pdf 15 page image

11The 6-button ClockYou can use the timer (Fig. 3.17) to turn the oven(s) onand off. The clock must be set to the time of day before theoven(s) will work.Table 3.1 describes the symbols shown on the digital display.Setting the Time of DayWhen the cooker is first connected to the mains, or if therehas been a prolonged power interruption, the clock displayflashes [ 0.00 ] and [AUTO].During the time setting process the centre dot will flash.When the process is complete the dot will stop flashing andthe [] symbol will be displayed.The time of day can be set in two ways:• Press and hold the [] button. Now press the [+] or [-]buttons to increase or decrease the time (Fig. 3.18).Holding the [+] or [-] buttons for more than 2 secondswill advance / decrease the set time quickly. Release thebuttons to set the time of day.• Press and hold both the [] and [] buttons down(Fig. 3.19). Now press the [+] button (or [–] button) untilthe correct time shows.Do not forget that it is a 24-hour clock.If you need to reset the clock/cooker, turn off the power andwait several minutes, then start again.Automatic DimmingProviding there are no automatic programs set, and theminute minder is not active, your clock will automatically dimduring the hours between 22:00 and 06:00.Minute MinderPress and hold the [] button (Fig. 3.20), and then press the[+] button (or [–] button) until the length of time you want tocook for is shown (Fig. 3.21).You can check the time remaining by pressing []. When thebeeper sounds cancel it by pressing any button.• The ‘cook period’, which is the length of time youwant the oven to cook for.• The ‘stop time’, which is the time of day you want theoven to stop cooking.Setting a Cook DurationPress and hold the [] button and set the required ‘cookperiod’ by pressing the [+] button (or [–] button) (Fig. 3.22).The clock will now control the cook period of your oven(s).The [] symbol and [AUTO] will be displayed.Once the ‘cook period’ is reached, the beeper sounds and the[AUTO] symbol flashes. Turn the oven control knob to 0 andthen press any button to stop the beep. Press [] to return tomanual cooking.ArtNo.302-0002 - 6BC annotatedArtNo.302-0002 - 6BC annotated ArtNo.302-0002 - 6BC annotatedArtNo.302-0002 - 6BC annotatedArtNo.302-0002 - 6BC annotatedArtNo.302-0002 - 6BC annotatedA B C D E FA – Minute minder, B – ‘Cook’ time, C – ‘Stop’ time, D – Manual,E & F – Time setting buttonsFig. 3.17Fig. 3.18 Fig. 3.19Fig. 3.20 Fig. 3.21Fig. 3.22Symbol Function Notes[] Minute Minder is active[] Oven(s) can be operatedIf the ‘cook’ [] symbol is notdisplayed the program has either:• ended and the oven(s) are non-operational• the oven(s) are being controlledby an automatic program thathas not started[AUTO]Oven(s) are beingcontrolled insemi-automatic orautomatic mode[P] Self clean (pyrolytic)mode has been enabledYour cooker may not have thispyrolytic function[dot] Flashes during settingthe time of dayTable 3.1