Rangemaster Professional + 100 User's Manual & Installation Instructions

Also see for Kitchener 100: User's guide & installation instructions

Rangemaster Professional + 100 User's Manual & Installation Instructions Manual pdf 23 page image

19Hotplate ignition or hotplate burners faultyIs the power on? Is the clock illuminated?If not, there maybe something wrong with the powersupply.Are the sparker (ignition electrode) or burner slotsblocked by debris.?Are the burner trim and caps correctly located? See thesection on ‘Cleaning’.Hotplate burners will not lightMake sure that the burner parts have been replacedcorrectly after wiping or removing for cleaning.Check that there is not a problem with your gassupply. You can do this by making sure that other gasappliances you may have are working.Do the burners spark when you push the control?If not, verify that the power is on by checking that theclock is illuminated.Steam is coming from the ovenWhen cooking foods with high water content (e.g. ovenfries) there may be some steam visible at the rear grille.Take care when opening the oven door, as there maybe a momentary puff of steam when the oven dooris opened. Stand well back and allow any steam todisperse.What cleaning materials are recommended for thecooker?See the ‘Cleaning’ section for recommended cleaningmaterials.nn Never use caustic or abrasive cleaners as these willdamage the surface.An oven fan is noisyThe note of the oven fan may change as the oven heatsup – this is perfectly normal.The knobs get hot when I use the oven or the grill. Can Iavoid this?Yes, this is caused by heat rising from the oven or thegrill, and heating them up. Do not leave the oven dooropen.Make sure that the grill pan is pushed right back to the‘back stop’ when grilling.Always grill with the grill compartment door open.The fascia gets hot when I use the oven or grillThe cooker is cooled by a fan. If the fascia becomesexcessively hot when the cooker is in use then thecooling fan may have failed. Should this occur pleasecontact your installer, a qualified repair engineer orCustomer Service to arrange for its repair.If there is an installation problem and I don’t get myoriginal installer to come back to fix it who pays?You do. Service organizations will charge for their callouts if they are correcting work carried out by youroriginal installer. It is in your interest to track down youroriginal installer.Power failureIn the event of a failure in the electrical supply,remember to reset the clock to make sure that thetimed oven continues to operate.Fascia illumination is not coming on (Hi-LITE only)Is the power on?The appliance has developed a fault that cannot berectified by the user. Please contact your installer or aqualified repair engineer.Food is cooking too slowly, too quickly, or burningCooking times may differ from your previous oven.Check that you are using the recommendedtemperatures and shelf positions – see the ovencooking guide. The oven control settings and cookingtimes are intended to be used only as a guide.Individual tastes may require the temperature to bealtered either way, to get the results you want.The oven is not cooking evenlyDo not use a baking tray with dimensions larger thanthose specified in the section on ‘General Oven Tips’.If you are cooking a large item, be prepared to turn itround during cooking.If two shelves are used, check that space has been leftfor the heat to circulate. When a baking tray is put intothe oven, make sure that it is placed centrally on theshelf.Check that the door seal is not damaged and that thedoor catch is adjusted so that the door is held firmlyagainst the seal.A dish of water when placed on the shelf should be thesame depth all over. (For example, if it is deeper at theback, then the back of the cooker should be raised up orthe front lowered.) If the cooker is not level arrange foryour supplier to level it for you.Oven not coming onIs the power on? Is the clock illuminated? If not, theremay be something wrong with the power supply.Is the cooker supply on at the isolator switch?Has the time of day been set?Is the key symbol [] showing in the display to signifythat the oven is locked? See the ‘Clock’ section of theinstructions for more information on the key lockfeature.7. Troubleshooting