Rangemaster Professional + 100 User's Manual & Installation Instructions

Also see for Kitchener 100: User's guide & installation instructions

Rangemaster Professional + 100 User's Manual & Installation Instructions Manual pdf 29 page image

INSTALLATIONCheck the appliance is electrically safe and gas sound when you have finished.25Conversion to Another GasIf the appliance is to be converted to another gas do theconversion at this point. See the conversion section of theseinstructions.LevellingYou are recommended to use a spirit level on a shelf in one ofthe ovens to check for level.Place the cooker in its intended position, taking care not totwist it within the gap between the kitchen units as damagemay occur to the cooker or the units.The front feet and rear rollers can be adjusted to level thecooker.To adjust the height of the rear of the cooker use a 13 mmspanner or socket wrench to turn the adjusting nuts at thefront bottom corners of the cooker.To set the front, turn the feet bases to raise or lower.Gas ConnectionThis must be in accordance with the relevant standards.The flexible hose (not supplied with the cooker) must bein accordance with the relevant standards. Hoses may bepurchased at most builders’ merchants.We recommend that a Micropoint gas hose is used wheninstalling this appliance.The gas supply needs to terminate with a side-facing elbowwith a down-facing bayonet.The connector is located just below the hotplate level at therear of the cooker. If in doubt contact your supplier.The rear cover boxes limit the position of the supply point.Because the height of the cooker can be adjusted andeach connection is different, it is difficult to give precisedimensions.Although a 900 mm hose can be used (on the Hi-LITE modelwe recommend a 1250 mm hose), a 1250 mm hose will allowslightly more flexibility in the positioning of the bayonet andmake moving the cooker easier.The hose should be fitted so that both inlet and outletconnections are vertical so that the hose hangs downwards ina ‘U’ shape.Ideally the hose supply connection should be within theshaded area ‘A’ (Fig. 8.10 or Fig. 8.11 on Hi-LITE & Classicmodels).For Natural Gas, the flexible hose must be in accordance withBS 669. For LP Gas, it should be capable of 50 mbar pressureand a 70 °C temperature rise. If in doubt contact, yoursupplier.Screw connect the threaded end of the hose into the gasinlet.After completing the gas connection, make sure that thecooker is gas sound with a pressure test.680450750A500All dimensions in millimetresGas inlet290130370140225A30Gas inletAll dimensions in millimetresFig. 8.10Fig. 8.11