Rangemaster Professional + 100 User's Manual & Installation Instructions

Also see for Kitchener 100: User's guide & installation instructions

Rangemaster Professional + 100 User's Manual & Installation Instructions Manual pdf 21 page image

17Glass Fronted Door PanelsThe oven door front panels can be taken off so that the glasspanels can be cleaned. Move the cooker forward to gainaccess to the sides (see the ‘Moving the Cooker’ section under‘Installation’).Open the oven door slightly and remove the front panelfixing screws from the door sides, two each side (Fig. 6.10).Carefully lift off the outer door panel. The inside face of theglass panels can now be cleaned – take care not to disturb orwet the door insulation.Note: If the door is triple glazed then the inner two panels arefixed together and should not be separated.After cleaning, carefully refit the outer door panel and replacethe side fixing screws.nn DO NOT use harsh abrasive cleaners or sharp metalscrapers to clean the oven door glass since they canscratch the surface, which may result in shattering ofthe glass.Ovens‘Cook & Clean’ PanelsThe main oven has panels which have been coated with aspecial enamel that partly cleans itself. This does not stopall marks on the lining, but helps to reduce the amount ofmanual cleaning needed.The ‘Cook & Clean’ panels work better above 200 °C. If you domost of your cooking below this temperature, occasionallyremove the panels and wipe with a lint free cloth and hotsoapy water. The panels should then be dried and replacedand the oven heated at 200 °C for about one hour. Thiswill make sure that the ‘Cook & Clean’ panels are workingeffectively.DO NOT use steel wool, oven cleaning pads, or any othermaterials that will scratch the surface.Removing the Main Oven LiningsSome of the lining panels can be removed for cleaning.If you wish to clean the enamel interior of the oven, youwill need to remove the shelves before removing the ‘Cook& Clean’ panels . You do not have to remove the supportbrackets to remove the panels. Lift each panel upward andslide forward off the support brackets (Fig. 6.11).Once the panels have been removed, the oven enamelinterior can be cleaned.Refit in the reverse order.The Tall OvenTo clean the oven sides, slide out the shelves, unhook thesupports from the oven sides, and lift out (Fig. 6.12).ArtNo.320-0002a Proplus oven door side screwsFig. 6.10Fig. 6.11Fig. 6.12