CHAPTER 2: I NSTALLATION 117. Re-Configure: Paragon II will automatically configure the system as computers or devices are addedor removed. However, the system administrator can use this function to scan and re-configure thesystem manually. When complete, it will return to normal display.Re-ConfigureSearching Now…Figure 16 Auto Configure8. Set IP Address: As administrator, you may change Paragon II’s IP address directly from the frontpanel of the device. The Paragon II’s current IP address will be displayed, along with a cursor. Use the[]and [Æ]keys to move the cursor over digit-by-digit, and use the [Ç] or [È]arrow keys to changethe value of that digit. Press the [ENT] button when the new IP address has been set. Press the [ENT]button again to save changes and reboot the unit when asked to “Save Changes?” The unit will restartwith the new network address.Note: Stacking units do not have their own databases and configurations settings, and likewise, do not havetheir own network addresses. You cannot configure one using the front panel controls on UMT E units.9. Reset Unit (Paragon II Unit Switch): Enables restart of Paragon II unit as if unit’s power had beenphysically turned off and back on again. However, the Paragon II unit will not perform start-up testunless ENT button is held down during restart.With Paragon II unit firmware 2B1 and User Station (UST1) firmware 2K10 or higher, either a powerreset or a factory “function” reset can be performed from the front panel of the Paragon II unit usingshortcut button combinations.Power Reset:Hold the [Ç] and [È] buttons on the front panel of the Paragon II unit simultaneously for approximatelythree seconds. When the front panel stops scrolling, release the buttons.Factory “Function” Reset:Hold the [Ç] and [È] buttons on the front panel of the Paragon II unit simultaneously while pressing the[FUNC] button. When the front panel stops scrolling, release the [Ç] and [È] buttons, wait an additionalthree seconds, then release the [FUNC] button.
