46 PARAGON II USER M ANUALConnecting Z-CIMs as TiersThe following diagram shows the final setup when connecting Z-Series Z4200U Z-CIMs as a tier:Figure 42 Connecting a Z-CIM as a Tier to Paragon IIImportant: Z-Series installation requires that each computer be assigned a channel name as it isadded to the Z-CIM chain. Computer channels are organized alphabetically by assigned name (orthe default name, the Z-CIM’s serial number), rather than in the order of their placement within theZ-CIM chain. We recommend that installers assign channel names before connecting allcomputers to eliminate any difficulty in locating the respective channel for each computer.Note: When following the installation and configuration instructions below, sort the Selection Menu byChannel ID Number, not by Name. Display the menu by pressing [F2] and change the sorting method bypressing [F12].All Paragon II components must be powered ON prior to Z-CIM tier installation. All computers in the Z-CIM chain and all Z4200U components must be powered OFF prior to installation.Connect a Z-CIM as a Tier:1. Connect a Category 5e UTP cable to the channel port on the Paragon II unit reserved for the Z-CIMchain.2. Connect the other end of this Category 5e UTP cable to the UTP OUT port on a Z-CIM, which will bethe first Z-CIM in the chain.3. Connect a computer to the first Z-CIM.For UKVMSPD Z-CIM:a. Connect the 6-pin mini-DIN keyboard and mouse and HD15 video connectors on the UKVMSPDZ-CIM to computer’s keyboard, mouse, and video ports.b. Place the Z-CIM Terminator in the Z-CIM’s UTP IN port.c. Power ON computer.For UKVMSC Z-CIM with local port:a. Connect DB25 male end of CCPnn cable to DB25 female port on back of a Z-CIM (UKVMSC).b. Connect other end to computer’s keyboard, video, and mouse ports.IN OUT PC Last Z-CIMZ-CIM TerminatorZ-CIMsZ-CIMZ-CIMsUp to 42 Cat5eCat5eCa et5ServersUp to 42UKVMSPDUKVMSPDUKVMSPDCa et5Ca et5Back of P2-UMT832