APPENDIX D: PARAGON II RACK M OUNT 69Appendix D: Paragon II Rack MountParagon II User Stations and most Base Units can be mounted in 1U (1.75", 4.4 cm) of vertical space in astandard 19" equipment rack; P2-UMT1664M Base Units can be mounted in 2U (3.5", 8.9 cm) of space. Torackmount a Base Unit, use the brackets and screws that came with the unit; to rackmount a User Station,use the RMKSMU rackmount kit. (If you lose or damage a Base Unit’s brackets, replace them with theRMKSM1 kit [for any 1U Base Unit] or RMKSM2 [for a P2-UMT1664M].) You can mount a Base Unit orUser Station facing the front of the rack or facing the rear.Forward Mount1. Secure the cable-support bar to the back end of the side brackets using two of the included screws.2. Slide the User Station or Base Unit between the side brackets, with its rear panel facing the cable-support bar, until its front panel is flush with the “ears” of the side brackets.3. Secure the User Station or Base Unit to the side brackets using the remaining included screws (three oneach side).4. Mount the entire assembly in your rack and secure the side brackets’ ears to the rack’s front rails withyour own screws, bolts, cage nuts, etc.5. When you attach cables to the connectors on the rear panel of the User Station or Base Unit, drapethem over the cable-support bar.Figure 60 Front rackmount of a P2 Base UnitFigure 61 Front rackmount of a P2 User Station1.1.2.3.3.4.4.5.P2-UMT8321.1.2.3.3.4.4.5.P2-UST