46 PARAGON II USER G UIDE• This function can be remotely triggered through Raritan’s IP-Reach (if any).Note: Accessing the ACTIVATOR channel with the Forced Video command CANNOT trigger theMultiple Video function. The associated channels will not output their data automatically.Exit the Multiple Video ModeThe hot key for triggering the OSUI is disabled on FOLLOWER User Stations. Therefore, chooseone method below to make the User Station(s) exit the Multiple Video mode.• On the ACTIVATOR User Station, press the hot key (default: Scroll Lock) twice quickly totrigger the OSUI, and then do one of the following. Both of the ACTIVATOR andFOLLOWER User Stations will exit the mode.− Press Shift+F9 to disconnect the ACTIVATOR channel− Press F9 to log out of the system− Choose another channel in the Selection Menu• Directly power cycle the desired User Station(s), be it an ACTIVATOR or FOLLOWERUser Station.Note: If the User Station is P2-USTIP, it automatically enters the remote mode when logged outof the Multiple Video mode. Press Ctrl+Alt+Delete on the P2-USTIP if you want to return to thelocal mode.LimitationThe function is not applicable to those channels which share only one path via the tiered device,such as P2ZCIM, P2CIM-APS2-B or P2CIM-AUSB-B (for IBM BladeCenter servers).Messages on the ACTIVATOR User StationThe success and/or failure of data outputs of the FOLLOWER channel(s) will be displayed on thescreen of the ACTIVATOR User Station (see the sample image below).The 4 th channel did NOT output its datasuccessfully.The 3 rd channel output its data successfully.The 2 nd channel output its data successfully.Every channel output its data successfully.Figure 49 Sample Messages for Multiple Video Output ResultsThe failure of data output can be caused by one of the following reasons:• Blockage to the FOLLOWER channel port(s). For example, other user(s) may be accessingone or more of the FOLLOWER channels in Private mode and thus block the access.
