36 UST-IP USER MANUALPerformance SettingsThe Performance Settings screen is used to set up UST-IP’s video data transfer and bandwidth parameters.• Pause video stream for idle users: Pausing the flow of video data during periods of prolongedinactivity will prevent an inactive user from needlessly consuming bandwidth.- Never (default): Video data will continually be sent to Remote PC, constantly updating thescreen, even if the remote user is Idle, sending no active input to UST-IP.- After 5, 15, 30, 60, or 120 minutes: Video data flow to the Remote PC will pause after theselected time period has passed with no active input from the Remote PC.• Maximum total Bandwidth usage: Sets an upper limit to the amount of bandwidth that can beconsumed by this one UST-IP unit.- No Limit (default): UST-IP can consume as much bandwidth as needed.- 10, 5, 2, or 1 megabit or 512, 256, 128 kilobit: Total bandwidth available to be consumed bythis UST-IP unit is limited to the selected quantity. The lower the bandwidth allowed, theslower the performance that may result.• Maximum Bandwidth per user: Sets an upper limit to the amount of bandwidth that can beconsumed by each user logged onto this one UST-IP unit.Note: The availability of concurrent remote access is determined by the global setting PC Share Mode onthe Security Configuration screen, or individually by user profile through the Keyboard and MouseControl and Concurrent Access Mode settings on the User Account Settings screen. Control of UST-IP anda connected Target Server is based on first active keyboard/mouse input, so multiple remote usersattempting keyboard input or mouse movement at exactly the same moment may experience uneven control.- No Limit (default): Each active user can consume as much bandwidth as needed.- 10, 5, 2, or 1 megabit or 512, 256, 128 kilobit: Bandwidth consumed by each active userduring the operation of this UST-IP unit is limited to the selected quantity. The lower thebandwidth allowed, the slower the performance that may result.Press <Ctrl+S> to save changes or <Esc> to cancel changes, and return to Configuration Menu. SavedPerformance Settings changes will not take effect until UST-IP is restarted.