User and maintenance manual for stoves with RDS technologyPag.601/02/20163. GeneralThe Stove must only operate in rooms. As it is controlled by an electronic board, combustion is completely automatic and controlled andthe control unit regulates the ignition phase, 5 levels of power and the switching off phase, guaranteeing safe functioning.Most of the ashes produced by the combustion of the pellets fall into the collection drawer.However, always check the fire pot every day, as not all pellets have high standards of quality and could leave residue that is difficult toremove.The glass has a special air circulation for self-cleaning. However, a slight greyish film cannot be avoided after a few hours offunctioning.As already mentioned earlier, pellets with a diameter of 6 mm must be used with the stove.3.1 ResponsibilityRavelli declines all responsibility, both civil and criminal, with the delivery of this manual, for any accidents deriving from partial or totalfailure to observe the instructions it contains,Ravelli declines all responsibility deriving from the improper use of the stove, from its incorrect use by the user, by unauthorizedmodifications and/or repairs or from the use of spare parts which are not original.The manufacturer declines all direct civil or criminal responsibility due to:- poor maintenance- failure to observe the instructions in the manual- use not compliant with the safety instructions- installation that is not compliant with the regulations in force in the country.- installation by personnel who are not qualified or authorized- modifications and repairs that are not authorized by the manufacturer- use of spare parts that are not original- exceptional events3.2 Compliance statusThis manual describes the installation and operation of the Ravelli, Francesca 2015, Monica 2015, RV80 ceramica wood pellet heater.This heaters meet the 2020 U.S. Environmental Protection Agency’s wood pellet emission limits for wood heaters sold after May 15th2015. Under specific test conditions this heater has been shown to deliver heat at rates ranging from 10733 to 26556 Btu/hr.3.3 Spare partsUse original spare parts only. Do not use any substitute material. Do not wait for the components to be worn before replacing them.Replace a worn component before it is completely broken to prevent any accidents caused by the sudden breakage of components,perform the periodic maintenance checks as described in the dedicated chapter. Removal of broken or damaged components shall beonly done by authorized technical service.- This wood heater needs periodic inspection and repair for proper operation. It is against federal regulations to operate thiswood heater in a manner inconsistent with operating instructions in this manual. - This wood heater has a manufacturer-setminimum low burn rate that must not be altered. It is against federal regulations to alter this setting or otherwise operate this wood heaterin a manner inconsistent with operating instructions in this manual.-This heater is designed to burn wood pellet only.DO NOT BURN ANY OTHER FUEL. Burning other materials may result in release oftoxic fumes or render the heater ineffective and cause smoke.- Do not overfire. Attempts to achieve heat output rates that exceed heater design specifications can result in permanent damage to theheater.- Flues gases contain carbon monoxide (CO), it is reccomended to install smoke monitors and CO monitors for areas that are expectedto generated CO. Inspect the the chimney to minimize visible emissions.- Soot and Flyash: Formation and Need for Removal—The products of combustion will contain small particles of flyash. The flyash willcollect in the exhaust venting system and restrict the flow of the flue gases. Incomplete combustion, such as occurs during startup,shutdown, or incorrect operation of the room heater will lead to some soot formation which will collect in the exhaust venting system.The exhaust venting system should be inspected at least once every year to determine if cleaning is necessary.Emission Rate (g/hr) Heating Efficiency (%Overall) 1st hour EmissionRate (g/hr) CO emission gr/hrFrancesca 2015, Monica2015 and RV80 Ceramica 0.58 77.90% 1.36 23RV100 Classic 0.7 80.2% 0.67 2.72Roma 0.74 75.5% 1.33 9.45This manual describes the installation and operation of the Ravelli, Roma wood pellet fireplace insert. This heater meets the 2020 U.S.Environmental Protection Agency’s wood pellet emission limits for wood heaters sold after May 15th 2015. Under specific test conditionsthis heater has been shown to deliver heat at rates ranging from 10250 to 31500 Btu/hr.This manual describes the installation and operation of the Ravelli, RV100 cLASSIC wood pellet heater. This heaters meet the 2020 U.S.Environmental Protection Agency’s wood pellet emission limits for wood heaters sold after May 15th 2015. Under specific test conditionsthis heater has been shown to deliver heat at rates ranging from 10750 to 34500 Btu/hr.