Raven AutoBoom 9600 Installation Manual

Contents

Raven AutoBoom 9600 Installation Manual Manual pdf 43 page image

4Manual No. 016-0230-096 37POWERGLIDE PLUSINSTALL THE POWERGLIDE PLUS WIRINGWiring ConnectionsFor wiring connections made outside the cab, apply dielectric silicone grease (P/N 222-0000-006) generously onboth the male and female ends of the connectors. Application of the grease will prevent corrosion to the pins andwires.INSTALL THE AUTOBOOM NODEFIGURE 15. AutoBoom Node Installed1. Use the existing holes on one edge of the supplied mounting plate (P/N 107-0171-619) as a guide to drill two 3/8” holes in the machine’s center rack.1. Place the AutoBoom node (P/N 063-0130-010) on the supplied mounting plate.2. Use the AutoBoom node as a guide to mark and drill three 3/8” holes in the mounting plate.3. Fasten the AutoBoom node to the mounting plate using three 3/8”-16 zinc hex bolts (P/N 311-0054-106) andthree 3/8”-16 zinc flanged lock nuts (P/N 312-1001-164).4. Using the drilled holes, secure the mounting plate to the machine’s center rack using two 3/8”-16 zinc hex bolts(P/N 311-0054-106) and two 3/8”-16 zinc flanged lock nuts (P/N 312-1001-164).5. Insert the large, rectangular node connectors on the harness cable (P/N 115-0230-045 or 115-0230-085) intothe correct ports of the AutoBoom node.6. Tighten the bolts on the node connectors to secure the connections.CONNECT THE HARNESS TO THE BOOM FUNCTION CONTROLS1. Locate the Left Press and Right Press connectors on the harness cable (P/N 115-0230-045 or 115-0230-085).2. Route the connectors to the AutoBoom valve (P/N 063-0131-126).CAUTIONAlways connect the power cable as the last stepin the wiring process and verify that the powerleads are connected with the correct polarity.Reversing power leads can cause severe damageto the equipment.