Raven AutoBoom 9600 Installation Manual

Contents

Raven AutoBoom 9600 Installation Manual Manual pdf 62 page image

C HAPTER 556 Fast 9600 - 80’-120’ Booms AutoBoom Installation Manual1. Locate the left and right ultrasonic sensors (P/N 063-0130-012 and 063-0130-014) in the AutoBoom installationkit.2. Remove the sensor from the existing plastic arm.3. Install the sensors on the 12” S-type sensor arms (P/N 063-0131-592) using the supplied 5/16”-18 x 1-1/4” bolts(P/N 311-0052-106), 5/16”-18 nylon insert lock nuts (P/N 312-4000-059) and 5/16” zinc flat washers (P/N 313-2300-012).4. Secure the left sensor (P/N 063-0130-014) to the front of the left boom using two 1-9/16” W x 2-1/2” L x 3/8”thread U-bolts (P/N 107-0171-611) and four 3/8”-16 zinc flanged lock nuts (P/N 312-1001-164).5. Tighten the nuts to ensure the sensor is mounted securely.6. Repeat the steps above to mount the remaining boom sensor(s).MOUNT THE CENTER RACK SENSORFIGURE 10. Center Rack Sensor1. Mount the center sensor (P/N 063-0130-018) to the machine’s center rack using two 2” W x 7” L x 3/8” threadU-bolts (P/N 107-0171-855) and four 3/8”-16 zinc flanged lock nuts (P/N 312-1001-164).2. Tighten the nuts to ensure the sensor is mounted securely.CONNECT THE SENSOR CABLES1. Connect the left sensor cable (P/N 115-0171-527) to the connector on the outer left sensor.2. Route the left sensor cable toward the AutoBoom valve.3. Loop and tie-off any excess cabling, allowing enough cable for boom folding and extension.4. Repeat the steps above to connect the remaining sensor cables.NOTE: The sensor cables will be connected to the AutoBoom system in the wiring phase of installation.INSTALL THE GAUGE WHEELS - OPTIONALGAUGE WHEEL MOUNTING LOCATIONSWheel mounting locations may be influenced by the boom configuration. Determine the appropriate location formounting the wheels on the boom, ensuring the wheels will not interfere with or be damaged while folding or