Raven AutoBoom Installation Manual

Also see for AutoBoom: Installation manual Installation manual Installation manual Installation manual Installation manual

Contents

Raven AutoBoom Installation Manual Manual pdf 50 page image

Chapter 446 Case IH 3150/3185, Pre-2002 Tyler Patriot Open Center AutoBoom™ Installation ManualConnect the Harness to the Boom Function Controls1. Locate the Left Press and Right Press connectors on the AutoBoom harness cable (P/N 115-0230-045 or115-0230-085).2. Route the connectors to the AutoBoom valve (P/N 063-0131-125).3. Connect the Left Press connector to Port G1 on the AutoBoom valve.4. Connect the Right Press connector to Port G4 on the AutoBoom valve.5. Locate the Left Solenoid and Right Solenoid connectors on the harness cable.6. Connect the Left Solenoid connector to Port 4A on the AutoBoom valve.7. Connect the Right Solenoid connector to Port 4B on the AutoBoom valve.8. Locate the Left Prop and Right Prop connectors on the harness cable.9. Connect the Left Prop connector to Port 5A on the AutoBoom valve.10. Connect the Right Prop connector to Port 13A on the AutoBoom valve.FIGURE 14. Machine’s Left and Right Tilt Boom Function Coils11. Locate the machine boom function coils near the machine’s boom hydraulic valve.12. Disconnect the connector from the machine’s Left Tilt Up coil.13. Install a boom sense adapter cable (P/N 115-0171-558) between the coil and the machine’s coil connector.14. Connect boom sense adapter cables between the left tilt down, right tilt up, and right tilt down coils and thecoil connectors.15. On the harness cable, locate the Left Solenoid Sense connectors. Isolate the connector labeled Up andconnect it to the left tilt up coil via the installed boom sense adapter cable.16. Connect the down Left Solenoid Sense connector to the left tilt down coil via the installed boom senseadapter cable.17. Connect the Right Solenoid Sense connectors to the machine’s right tilt up and right tilt down coils via theinstalled boom sense adapter cables.