Raven CR7 Operation Manual

Also see for CR7: Operation guide Manual Installation manual Quick start guide Installation guide

Contents

Raven CR7 Operation Manual Manual pdf 47 page image

45ADJUSTING SECTION CONTROLThe number of sections is based on the information entered while creating theimplement. The default settings for On Override is five seconds and the default TurnOff Percent is 95%. To adjust the number of sections, adjust the tractor settings.NOTE: The On/Off Override feature allows the operator to override theautomatic section control and force all AccuBoom controlled sectionson for a user defined interval. This feature is useful to re-apply productto a heavily infested field area or when accelerating from a completestop. The time for the override may be modified to match specificapplication needs.Turn Off/On Percent allows the user to define the amount of coveragetolerated during an application. For applications which requirecomplete coverage, the coverage percent setting should be set to ahigher value (80% to 100%). When applying products that do nottolerate overlaps, the percent coverage should be set to a lower value.On/Off Look Ahead monitors the GPS position and coverage map whileconsidering the look ahead times to begin controlling sections on or offbefore the section crosses spray or no-spray boundaries. Look aheadtimes may help compensate for delays in the sprayer system includingthe time it takes for boom or control valves to open.• Adjust the Off Look Ahead to determine how far (in seconds) to turn a section off.• Adjust the On Look Ahead to determine how far (in seconds) to turn a section on.NOTE: Off Look Ahead is the amount of time before entering an alreadyapplied area or a no spray zone that the section will turn off.On Look Ahead is the amount of time before area that needs to beapplied that a section will turn on.To adjust the Off Look Ahead, On Look Ahead, On Override, and Turn OffPercentage:1. On the CRX Settings page, select Section Control .2. Press in the cell to the right of the desired setting.3. Enter the desired setting.NOTE: If using a Raven AccuBoom node, select the Use AccuBoom checkboxand the AccuBoom node will control the sections for the implementselected in the drop-down list.