Chapter 3: Standard Chart Operations 3-33Stop Follow or StopGoto2. Press the GOTO WAYPOINT soft key.Navigation to the selected waypoint begins. The soft key STOP GOTO is dis-played.3. To return to the default soft key display, move the cursor away from thewaypoint or press ENTER or CLEAR.➤ To navigate directly to the cursor position:1. Use the trackpad to position the cursor as required.2. Press the GOTO default soft key, followed by GOTO CURSOR.If navigation is currently in progress you are warned “Already followingroute. Cancel route and goto cursor?”.To cancel the GOTO CURSOR operation, press NO.To continue with the GOTO CURSOR operation (and stop the current GOTOROUTE), press YES.The chartplotter places a temporary waypoint as the target and starts tonavigate towards it. The waypoint is shown as a square with a circle anddot in the centre, and is connected to the vessel’s starting position with adashed line.The soft key STOP GOTO is displayed.3. To return to the default soft key display, move the cursor away from thewaypoint or press ENTER or CLEAR.Stop Follow or Stop Goto➤ To stop following the route or target pointeither:1. If necessary, press the GOTO soft key, then press the STOP GOTO/FOLLOWsoft key.Or:1. Move the cursor over any waypoint or leg in the current route, then pressthe STOP GOTO/FOLLOW soft key.The dotted line from your vessel to the target waypoint disappears.If you stopped a GOTO WAYPOINT or CURSOR, to remove the target point fromthe screen, move the cursor over the target point then press the CLEAR GOTOsoft key.If you subsequently use the FOLLOW ROUTE soft key to restart navigation, theroute is followed from the point at which it was stopped. This is indicated by asquare around the target waypoint. If you want to follow from anotherwaypoint you can initiate the follow then use the WAYPOINT ADVANCE orFOLLOW FROM HERE soft key to step through the route.GOTOWAYPOINTGOTOGOTOCURSORSTOPGOTOGOTOSTOPGOTOSTOPFOLLOW
