56TYPE 100/300 Operation and Installation HandbookType 2 Drive Unit (24V)Cable Length (Drive Unitto Course Computer)Cable Gauge Copper AreaUp to 3m (10ft) 12 AWG 2.5 mmUp to 5m (16ft) 10 AWG 4 mmUp to 7m (23ft) 8 AWG 6 mmUp to 10m (32ft) 6 AWG 10 mmUp to 16m (52ft) 4 AWG 16 mm81004-05Stern drive ActuatorThe stern drive actuator can be fitted to power assisted Stern drivesystems made by Volvo-Penta, Mercruiser, OMC and Yamaha. Differentinstallation kits are available to cover most of these installations.Note: Older Volvo steering systems (Pre type 872215) require an adaptorbracket (D129).MountingVolvo (Pre type 872215)Fitting to this type of engine requires an adaptor bracket (M81139).The stern drive actuator should be connected to the centre hole on thetiller arm. On twin engine installations, this is the position used to connectthe engine tie bar to link the two tiller arms.Hexagonalkey bolt(2 off)Springwasher (2 off)BracketclampMountingbracketLocationpinNyloc nutSplit pinSmallspringclipAdaptor pin(Multi-engine mount)Adaptor pin(Single engine mount)D768-1
