Chapter 3: Adjusting SmartPilot Settings 43Data pagesSmartPilot controllers have 15 user-configurable pages. The following screensallow you to modify the settings for the data pages. These define which SeaTalk/NMEA data pages will be available during normal operation (seeSmartPilotOperating Guide). Each data page setup screen initially shows the title DATAPAGE and the page number. After 1 second, the text changes to the title of thedata set for that page.The default settings are:Note:It is good practice to keep the BTWand DTWpages for display. If your SmartPi-lot receives a man overboard (MOB)message, these data pages will show the bearing anddistance to the MOBlocation.To change the data displayed on a data page:1. Press disp to move to the appropriate data page setup screen.2. Use the -1 and +1 keys or the rotary control to scroll forwards or back-wards through the available data pages (see following table).3. Then press disp to move to the next data page you want to change, or pressand hold standby for 2 seconds to save changes.Data Page Default Setting1 XTE (Cross Track Error)2 BTW (Bearing to Waypoint) - see Note below3 DTW (Distance to Waypoint) - see Note below4 RESPONSERemaining pages NOT USED (These pages are not displayed when you scrollthrough the data pages during normal operation)Available Data Pages Displayed asSpeed Knots SPEED KTSLog LOG XXXX.XTrip TRIP XXX.XAverage Speed, Knots AV. SPD KTSWind Direction e.g. WIND PORTWind Speed WIND KTS
