Raymarine SmartPilot X-5R Drive Installation & Setup

Contents

Raymarine SmartPilot X-5R Drive Installation & Setup Manual pdf 21 page image

Chapter 2: Installing the system 13Step 3 - Plan suitable mounting angleThe Drive unit MUST be mounted at an angle of no more than 35° from vertical, toensure adequate drainage of water for all rotating parts. You MUST also ensure thatthe drain hole at the base of the unit is kept clear at all times.Step 4– Prepare to fit torque restraint1. If the steering wheel shaft is 1 inch diameter, proceed from step 2 below. If theshaft is 3/4 inch diameter, slide the taper adaptor (supplied) fully onto the steeringwheel shaft taper, with the keyways are aligned.2. Temporarily place the SPX-5R Drive onto the steering shaft, with the torquerestraint at the lowermost point.D10663-13/4 inch Steering Shaft1 inch Steering Shaft3/4"steeringshaft1" steeringshaftSteering wheel(3/4" shaft fitting)Steering wheel(1" shaft fitting)Taper adaptorfits tosteering shaftTaper adaptor,fits to stub shaft